6
Adjustment for Positional Sensing
with the TD-8 or the TD-10
When the TD-8 or the TD-10 is used as the sound module, the
location at which the pad is struck can be varied to produce
tonal changes. In this case, it is important to adjust the head so
the tension is evenly distributed, so the striking location can be
detected accurately. For details on adjustments, refer to the TD-
8 or the TD-10 owner’s manual.
The TD-10 owner’s manual assumes use of the PD-100 and
PD-120 pads in its explanation. If you are using the PD-80 or
PD-80R, however, make adjustments while striking them 1
inch (3 cm) from the rim.
Attaching the Pad to a Stand
Attach the PD-80 or PD-80R to a stand (MDS series).
fig.P02.e
When attaching the PD-80/80R to a tom stand, check the
dimensions of the rod. Depending on the dimensions of the
rod, it may not be possible to attach the pad to the stand.
Acceptable rod diameters:
8.5–11.5 mm (3/8 to 1/2 inch)
Connecting to the Percussion
Sound Module
921
To prevent malfunction and/or damage to speakers or other
devices, always turn down the volume, and turn off the power
on all devices before making any connections.
When you have finished connecting to your drum sound
module, refer to the recommended parameters on p. 2, and
make the settings for the sound module.
Connecting to the TD-6V, TD-8, TD-10,
HPD-15, SPD-20, or SPD-S
• Use the included cable to make connections.
• With the PD-80R, make sure to use the supplied stereo
cable when connecting it. Otherwise (if you use a
monaural cable), you won’t be able to employ striking
location detection, rim shot, and cross stick playing
techniques.
• Connect the L-shaped plug of the included cable to the
PD-80/80R. This will prevent strain from being applied
to the PD-80/80R.
Correspondences Between Playing
Techniques and Percussion Sound Modules
* Rim shots and cross-stick performances can be made only with the
PD-80R.
Connecting to the TD-5, TD-7 or SPD-11
• Use the included cable to make connections.
• Connect the L-shaped plug of the included cable to the
PD-80/80R.
This will prevent strain from being applied to the PD-80/
80R.
• It is not possible to play rim shots even if you connect the
PD-80R to the TD-5, TD-7, or SPD-11.
Sound Module
Trigger inputs that allow
positional sensing
TD-8
3 (SNARE)
TD-10
2 (SNARE)
Rod
Pass the rod through the pipe
that is inside the holder.
Tighten
Loosen
Sound
Module
Trigger
Input
Rim
Shot
Cross
Stick
Positional
Sensing
TD-6V
2 (SNARE)
o
o
–
TD-8
3 (SNARE)
o
o
o
TD-10
2 (SNARE)
o
–
o
TD-10
(TDW-1)
2 (SNARE)
o
o
o
HPD-15
1, 2
o
–
–
SPD-20
1, 2
o
–
–
SPD-S
1, 2
o
–
–
Next
PD-80/PD-80RW.e4 6 ページ ２００４年３月１日 月曜日 午後２時２８分
