Switching Off the Print Heater and Dryer Together
This setting is useful when you want to switch off the media heating systems collectively. Setting "POWER" to
"OFF" in the heater settings will make it impossible to set the temperature of the print heater and dryer.
Procedure
1.
Press [FUNCTION].
2.
Press [
▼
] several times to display the screen shown below.
FUNCTION
HEATER CONFIG
3.
Press [
▶
] to display the screen shown below.
HEATER CONFIG
POWER ON
4.
Press [
▶
].
5.
Press [
▲
] or [
▼
] to select "OFF."
HEATER CONFIG
ON OFF
6.
Press [ENTER] to confirm your entry.
The settings for the print heater and dryer are turned off.
7.
Press [FUNCTION] to go back to the original screen.
MEMO
• Default setting: "ON"
IMPORTANT
When this is set to "OFF", the heater will not turn on even if the heater temperature is set in the software RIP.
Adjusting the Ink-drying Method
90
1. Optimizing the Output Quality
Summary of Contents for TrueVIS VF2-640
