11
MENU
SEND ([F2] button)
Parameter
Value
Explanation
[F3] button
OFF, REV ON
Turns reverb on/off.
PAD1<HEAD>–PAD6<RIM>
-INF–+6.0dB
Amount of reverb applied for each drum trigger
MEMO
If you press the [F1] (H&R) button to turn it “ON,” you can simultaneously make settings for the head
area and rim area.
MASTER COMP
This is a two-band equalizer that is provided for each kit.
The sound processed by the master compressor is output from the MASTER OUT jacks and the PHONES jack.
* If the Master Direct Sw is set to “DIRECT” in OUTPUT SETUP (p. 17), the master compressor effect is not applied to the sound that is output from the MASTER OUT jacks.
Parameter
Value
Explanation
[F3] button
OFF, COMP ON
Turns master comp on/off.
[F2] button
–
Allows you to make detailed settings for the master compressor.
TEMPLATE
SINGLE SOFT COMP, SINGLE HARD
COMP, SINGLE LIMITER, 2 BAND SOFT
COMP, 2 BAND HARD COMP, 2 BAND
LIMITER
Character of the compressor
* When you change this parameter, all parameters of the master compressor change to optimal
settings for your selection. You can then make further adjustments to these parameters as
necessary. Depending on the settings of these parameters, the resulting effect might not match
the TEMPLATE setting.
Split Freq
SINGLE, 10–16000Hz
Bandwidth of the compressor
If this is “SINGLE,” the master compressor operates as a single-band compressor that is used only on
the high band.
DETAIL ([F2] button)
Parameter
Value
Explanation
Thrshd*1
-48–0dB
Volume level at which compression begins
Gain*1
-24–+24dB
Output level of the compressor
Atk*1
0.1–100mSec
Time from when the volume goes up the threshold level until the compressor effect applies
Rls*1
10–1000mSec
Time from when the volume falls below the threshold level until the compressor effect no longer
applies
Ratio*1
1:1–100:1
Compression ratio
Knee*1
HARD, SOFT1–3
Attack of the sound at the moment compression is applied
[F1] (LO) button*2
–
Switch the parameter display between the high-frequency and low-frequency bands when the
effect is operating as a two-band compressor.
[F2] (HI) button*2
–
[F3] (MONITOR) button*2
–
Allows you to individually audition the frequency band (low or high) currently selected in the tab
when the effect is operating as a two-band compressor.
* These settings are reset if you perform any of the following operations.
5
Respecify the Type parameter as single band compressor
5
Set the Split Freq parameter to “SINGLE”
5
Exit the MASTER COMP screen
*1 If Split Freq is set to something other than “SINGLE,” the low band and high band can be set independently.
*2 Only if Split Freq is set to something other than “SINGLE”
