Roland TD-6V, Service Notes

Page: 10 / 30

10
Feb.2004
CHECKING THE VERSION
NUMBER
1.
Turn the power on while holding down [KIT], [<], and [ENTER] button.
fig.ver
2.
To exit the software version display, turn off the power.
USERS DATA SAVE AND
LOAD
Bulk dump
To save data, use the external sequencer as you would when recording musical
data, and perform the following steps on the TD-6V as shown in the following
diagram.
1.
Use a MIDI cable to connect the TD-6V’s MIDI OUT connector to the
MIDI IN connector of the external sequencer.
2.
Holding down [SHIFT] and press [EDIT (SETUP)] button.
[EDIT] lights.
3.
Press [>] button to select “BULK DUMP.”
fig.svld01
4.
Press [ENTER] button.
5.
Press [INC/+] or [DEC/-] button to select the content to be saved
(“ALL”).
(ALL: All data, including the setup (trigger, pad, and other such
settings), drum kits, and User songs are transmitted.)
fig.svld02
6.
Start the recording process of the external sequencer.
7.
Press [ENTER] button.
8.
Press [ENTER] button to start the data transmission.
fig.svld03
Press [EXIT] button to cancel the operation.
Bulk load
1.
Use a MIDI cable to connect the TD-6V’s MIDI IN connector to the MIDI
OUT connector of the external sequencer.
2.
When receiving the TD-6V data stored in the MIDI instrument or PC, use
the same system exclusive device ID number as that used for the
exclusive data transmission.
3.
Send the setting data from the external sequencer to the TD-6V.
No special settings are required for the TD-6V to receive data from an
external sequencer.
Everything is done automatically.
* At this time, the TD-6V’s data is overwritten.
Save any data you need to an external MIDI device before carrying out
this operation.
* Set the Device ID used when the bulk data was saved.
Set the ID number
1.
Holding down [SHIFT] and press [EDIT (SETUP)] button.
[EDIT] lights.
2.
Press [>] button to select “MIDI COMMON.”
fig.svld04
3.
Press [>] button to select “Device ID.”
fig.svld05
4.
Press [INC/+] or [DEC/-] button to select the Device ID.