Roland SOLJET PROIII DU-540, User Manual

Page: 21 / 36

Chapter 1 Introduction 19
1-4 Installing on the Printer
Step 1: Install the Drying-heater Unit
WARNING Perform this task with all power switches left switched off.
Otherwise sudden movement of the machine may cause injury.
1.
Attach the arms.
➊
Attach the arms.
Line up the tab and attach.
1. Loosely tighten the two upper locations.
2. Loosely tighten the location on the side where the orientation of the screw is level with the floor.
3. Fully tighten the two upper locations, then fully tighten the remaining location.
➋
Attach the bushing and cable clamp to the right
arm.
Cable clamp
Right arm
Bushing
Tab
Tab
3 places 3 places