8
Parameter Guide
TONE Parameters
TONE COMMON
SH-101
Parameter
Value
Explanation
(name)
Tone name
Catg
CATEGORY
Selects the tone’s category.
TONE
SH-101
Parameter
Value
Explanation
CC#
LFO RATE
0–1023
Specifies the speed of the LFO cycle.
29
LFO WAVEFORM
TRI,
SQR,
S&H
Specifies the LFO waveform.
OSC LFO MOD
0–100
Adjusts the depth at which the LFO modulates
the OSC.
26
OSC RANGE
16’, 8’, 4’, 2’
Specifies the oscillator’s octave.
47
PULSE WIDTH
MOD
0–127
PW MODE =
MANUAL
Adjusts the pulse width value.
50
PW MODE =
LFO/ENV:
Adjusts the depth of modulation.
PW MODE
Specifies the pulse width mode.
LFO
The pulse width is affected by the LFO.
MANUAL
The pulse width is affected by PULSE WIDTH
MOD.
ENV
The pulse width is affected by ENV.
PW LEVEL
0–255
Adjusts the volume of the pulse wave.
16
SAW LEVEL
0–255
Adjusts the volume of the sawtooth wave.
17
SUB OSC LEVEL
0–255
Adjusts the volume of the sub oscillator.
18
SUB OSC
Specifies the SUB OSC type.
1OCT DN
One octave lower
2OCT DN1
Two octaves lower
2OCT DN2
Two octaves lower (small pulse width)
NOISE LEVEL
0–255
Adjusts the noise volume.
19
VINTAGE FLT TYPE
R, M, S
Selects one of three response curves, each
modeling the LPF of an analog synthesizer of
the past.
108
CUTOFF
0–1023
Specifies the cutoff frequency of the low-pass
filter. The frequency region above the cutoff
frequency is cut, producing a more mellow
tonal character.
3
RESONANCE
0–1023
Boosts the region of the filter’s cutoff frequency.
Higher values produce a stronger result, giving
the sound a distinctively synthesizer-like
character.
9
FLT ENV DEPTH
-1023–+1023
Adjusts the amount by which the cutoff
frequency is controlled by the envelope.
81
FILTER MOD
0–100
Adjusts the amount by which the LFO
modulates the cutoff frequency.
28
FLT KEY FOLLOW
0–200
Varies the filter’s cutoff frequency according to
the note played on the keyboard.
82
AMP ENV SEL
ENV F&A,
G-AMP
Specifies whether the volume is controlled by
the ENV (ENV F&A) or stays at a fixed volume as
long as the key is held down (G-AMP).
AMP LEVEL
0–127
Adjusts the volume of the tone.
110
ENV MODE
Specifies what causes the envelope to attack.
GATE+TRIG
Attack each time a key is pressed.
GATE
Attack when a key is pressed anew. No attack
when playing legato.
LFO
Attack repeatedly at each cycle of the LFO as
long as the key is held.
ENV ATTACK
0–1023
Specifies the ENV Attack time.
89
ENV DECAY
0–1023
Specifies the ENV Decay time.
90
ENV SUSTAIN
0–1023
Specifies the ENV Sustain level.
102
Parameter
Value
Explanation
CC#
ENV RELEASE
0–1023
Specifies the ENV Release time.
103
BEND PITCH
0–1500
Specifies the range of pitch change produced
by pitch bend.
BEND FILTER
0–63
Specifies the range of filter change produced
by pitch bend.
14
MODULATION
LFO
0–63
Specifies the amount of LFO applied by
modulation.
PORTA MODE
Turns portamento on/off. If this is on, the pitch will change
smoothly from one note to the next-played note.
OFF
Regardless of the portamento time setting,
portamento is not applied.
ON
Portamento is always applied.
AUTO
Portamento is applied only when you play
legato (pressing the next key before completely
releasing the previously-played key). This lets
you use your playing technique to control
portamento on/off.
PORTA TIME
0–1023
Adjusts the time over which the portamento
pitch change occurs.
5
PORTA CRV
Specifies the pitch change curve for portamento.
ORIGINAL
Change according to the original curve of the
model.
LINEAR
Change in a linear curve.
EXP1
Change in a non-linear curve (gentle slope).
EXP2
Change in a non-linear curve (steep slope).
KEY MODE
Specifies how notes are sounded.
119
POLY
Polyphonic
SOLO
Monophonic
UNISON
Unison
SL-UNISON
Monophonic unison
AFT LFO
-63–+63
Sets how much aftertouch changes the LFO
intensity .
* This is only enabled for products with aftertouch.
AFT FREQ
-63–+63
Sets how much aftertouch changes the low-
pass filter intensity.
* This is only enabled for products with aftertouch.
AFT LEVEL
-63–+63
Sets how much aftertouch changes the tone
volume.
* This is only enabled for products with aftertouch.
PITCH DRIFT
0–255
Adjusts the slight pitch drift that occurs when
notes are played on an analog synthesizer.
PARAM
EXPANSION
OFF, ON
If this is “ON,” the range of change for LFO RATE,
CUTOFF, RESONANCE, and FILTER ENV DEPTH is
wider than on the original model.
CONDITION
0–100
Simulates the changes that occur as a unit ages.
