Roland ROL-V-1HD, Manual

Page: 6 / 22

MIDI Implementation
6
„ {
Undefined (Controller Number 24)
Status 2nd Byte 3rd Byte
BnH 18H vvH
* This controls the state of the [EFFECTS B] knob. When this is set to “00H,” the effect
on bus B is turned off.
„ {
Undefined (Controller Number 25)
Status 2nd Byte 3rd Byte
BnH 19H vvH
* This controls the state of the [OUTPUT FADE] knob.
„ {
Undefined (Controller Number 26)
Status 2nd Byte 3rd Byte
BnH 1AH eeH
* This turns the FREEZE function on/off.
„ z
Program Change
Status 2nd Byte
CnH ppH
pp= Program Number: 00H–7FH (1–128)
* Select video input or memory number to match the bank select. For information on
control for bank select and program change, refer to “Bank Select”(p. 5).
* Unselectable program change will be ignored.
1-2. MIDI Visual Control Mode
„ „
Channel Voice Messages
„ z
Note On
Status 2nd Byte 3rd Byte
9nH kkH vvH
* This is received when Note Message Enabled of MVC is turned on.
* This selects the video channel corresponding to the note number.
* The setting range of note number is fixed by Keyboard Range Upper and Lower of
MVC.
* Unselectable note number or velocity will be ignored.
* The receiving channel is specified by Clip Control Ch. of MVC.
„ z
Control Change
„ {
Bank Select (Controller Number 0, 32)
Status 2nd Byte 3rd Byte
BnH 00H mmH
BnH 20H llH
mm,ll= Bank Number: 00 00H–7F 7FH (bank.1–bank.16384)
* The bank select processing is reserved until the unit receives program change.
* If unavailable bank select is received, the unit ignores it and receives program
change only.
* The received bank select information is withheld until the unit receives new bank
select.
* The receiving channel is specified by Clip Control Ch. of MVC.
* Select video input or memory number to match the program change. Control for
bank selects and program changes is as follows.
MSB
LSB Program No. Control
00H 00H 00H–03H A ch. INPUT 1–4
01H 00H 00H–03H B ch. INPUT 1–4
50H 00H 00H–07H MEMORY 1–8
„ {
General Purpose Controllers
(Controller Number 1-31, 64-95)
Status 2nd Byte 3rd Byte
BnH ccH vvH
cc= Controller Number: 01H–1FH, 40H–5FH
* The receiving channel of effect control and output fade control is specified by
Effect Control Ch. of MVC. The receiving channel for all the other controls is
specified by Clip Control Ch. of MVC.
„ z
Program Change
Status 2nd Byte 3rd Byte
CnH ppH
pp= Program Number: 00H–7FH (prog.1–prog.128)
* Select video input or memory number to match the bank select. For information
on control for bank select and program change refer to the “Bank Select” section
mentioned above.
* The receiving channel is specified by Clip Control Ch. of MVC.
* If unavailable program change is received, the unit ignores.