35
Connecting to MIDI Devices
Turning Transmission and
Reception of Control
Changes On/Off
Messages known as “Control Changes” are used to convey to
another device information about the instances where you
have pressed a pedal, or have turned On/Off the Chorus or
Reverb effects.
Each time the power is turned on, the instrument will always
be set to “On” (it will transmit/receive all Control Change
messages).
If you set it to “Off” the pt-2700 will no longer send or
receive any Control Change messages.
While holding down the [GRAND PIANO]
button, [UPRIGHT PIANO] button, and
[STRINGS] button, press the “A5” note to
turn the setting On, or the “B5” note to turn
the setting Off.
fig.8-12.e
If you want to know more about Control Change Number,
please refer to “MIDI Implementation Chart” (p. 39).
Transmitting Performance
Data from MIDI Out
If this setting is left “On,” performance data recorded on the
pt-2700 can be transmitted from the MIDI Out connector.
Each time the power is turned on, this setting will always be
at “Off.”
Hold down the [GRAND PIANO] button, the
[UPRIGHT PIANO] button, and the
[STRINGS] button, and press the “D6” note
to turn the setting On, or the “E6” note to
turn the setting Off.
fig.8-13.e
The performance data that you recorded will disappear
when the power of the pt-2700 is turned off.
If you wish to save the performance, use the following
procedure.
1.
Connect a MIDI sequencer such as the MT
series (p. 31).
2.
Record the performance on the pt-2700
(p. 22).
3.
Set this setting to “On.”
4.
Start recording with the connected MIDI
device.
5.
Start playback of the recorded song on the
pt-2700.
6.
When playback ends, stop recording with
the connected MIDI device.
7.
Use a connected MIDI sequencer to save
the data on a floppy disk or other media.
Off
On
Off
On
Summary of Contents for pt-2700
Page 2: ......
