9
- Communication errors due to interference
These data errors can be due to electrical or radio interference.
Malfunction may be caused by the cable being too long or radio interference picked up from a coiled cable.
Try replacing the cable with a shorter one or separating it from the power cord.
Check that there are no communication devices or motors producing radio interference nearby.
- Unstable power supply
Check if the malfunction only occurs while a device requiring a large amount of electricity is operating.
- Cutting overload
A malfunction may occur if the device is overloaded, for example, if the cutting-in amount is too large.
- Machine malfunction
There may be a faulty contact internally, or a malfunctioning circuit board. Check the connections.
If an error is shown on the iModela Control Panel, read the cause and do the appropriate procedure.
Q4:
The
bundled
software
cannot
be
started.
How
can
this
be
resolved?
A: Use Add or Remove Programs in the computer's Control Panel to delete the software, and then try installing it
again.
Q5:
The
start
point
and
end
point
of
cutting
are
not
aligned.
A: Try the following.
- Reduce the amount of extension of the tip of the cutter.
- Change the cutting parameters (lower the cutting speed, reduce the Z cutting-in amount, etc.).
- Clean or grease the drive system.
- Allow the drive system to idle.
- Check the data.
etc.
Q6:
The
cutting
‐
in
amount
differs
depending
on
the
location.
A: Placing the disposable board on the workpiece table and surfacing it increases the accuracy.
Affix a chemical wood board, for example, to the surface of the table, and then cut it with the straight end mill.
Affix the material to be cut on top of this. Cut it in the same way. The height of the material will be uniform with
the cutter, allowing stabilized cutting.
Summary of Contents for iModela
Page 1: ...iModela Trouble Shooting...
