Cleaning and Greasing
Chapter 3 Maintenance
38
Application of Grease to X, Y, Z Axes
When the X-, Y-, or Z-axis screws begin to make an unusual noise during operation, apply grease to the
screws.
Grease should be applied after approximately 50 hours of operation.
Procedure
If a cutting material is mounted, remove it.
Click the [X] and [Y] cursor buttons to move the cutter to the center of the operating
range.
(Standard coordinates: “X 43.00 mm,” “Y 27.50 mm”)
P. 7, "Operation of the Spindle Unit"
Click the [Z] cursor buttons to move the cutter to its lowest position.
P. 7, "Operation of the Spindle Unit"
Turn off the machine, and then apply grease to the X-, Y-, and Z-axis screws.
Refer to the following illustration and apply grease to the screw for each axis.
Note for Grease Application
Apply one drop of grease at each location. If too much grease is applied, cutting waste may become attach
to the grease, causing the machine to malfunction.
Be sure to use the supplied grease.
X-Axis, Z-Axis
Summary of Contents for iModela iM-01
Page 73: ...R2 111104 DOC 0943 ...
