Audio Follows Video
March 2010
Page 4 of 4
EDIROL V-440HD Setup
Make sure you have a video monitor connected to the SD Preview Output port so you can see the V-440HD menu.
1)
Perform MIDI Reset: Menu > 14. MIDI Setup > 32: MIDI Reset > Yes > ENTER.
2)
Press Menu to back out, then set: 14. MIDI Setup > 1: MIDI Sw Mode to V-LINK Sw. (the V-LINK LED
goes OFF)
3)
Exit Menu. Press V-LINK button (LED goes ON).
Test your setup by activating/fading video sources on the V-440HD and watching to make sure the
corresponding faders on your V-Mixer move up/down.
Note
:
you will not see SD source selections until you activate an A/B button on the active HD bus.
Note
:
when you power cycle the V-440HD you will need to turn on the V-LINK button by pressing it.
EDIROL V-8 Setup
Make sure you have a video monitor connected to the Preview Output port so you can see the V-8 menu.
1)
Perform MIDI Reset: Menu > MIDI Setup > MIDI Reset > Yes > ENTER.
2)
Press Menu to back out, then set: MIDI Out/Thru Switch to OUT.
3)
Press Menu to back out, then set: V-LINK Switch to ON.
Test your setup by activating/fading video sources on the V-8 and watching to make sure the corresponding
faders on your V-Mixer move up/down.
Note
:
when you power cycle the V-8 you will need to go back into the MIDI Setup menu and set "V-LINK Switch" to
ON.
EDIROL LVS-800 Setup
Make sure you have a video monitor connected to the A/B Mix Preview Output port so you can see the LVS-800
menu.
1)
Perform MIDI Reset: Menu > MIDI Setup > MIDI Reset > Yes > ENTER.
2)
Press Menu to back out, then set: MIDI Out/Thru Switch to OUT.
3)
Exit the Menu and press the V-LINK button (LED goes ON).
Test your setup by activating/fading video sources on the LVS-800 and watching to make sure the
corresponding faders on your V-Mixer move up/down.
Note
:
when you power cycle the LVS-800 you will need to turn on the V-LINK button by pressing it.
