user manual
15
DISARMING AN ARMED SYSTEM AND/OR SILENCING AN ALARM
STEP DESCRIPTION
1
If outside the premises, open an "entry" door. The keypad(s) will
beep—indicating that the Entry Delay period has begun.
2
Disarming an armed system
Before the Entry Delay expires,
Enter your User Code and press .
NOTE: If you make a mistake when entering your User Code,
the keypad will produce three short beeps. If so, re-enter the
above sequence correctly.
2
Silencing an alarm
Observe the keypad. If any of the following conditions is evident,
an alarm has occurred:
For LED KP:
·
x
The ARM LED is flashing.
·
x
A Zone LED is lit steadily.
·
x
The FIRE LED is lit steadily.
For LCD KP: the ARM LED is flashing, and the display will show
the disturbed zone
Enter your User Code and press .
If an alarm occurred, the ARM LED and the corresponding zone-
LED will flash for Alarm memory period of about 60 sec.
If using LCD keypad scroll through the list of alarmed zones
To exit alarm memory before timeout expired press [*]
Note:
It's best to leave the premises. Only after police
investigation should you consider that the burglar is no longer in
your premises and you can re-enter.
In special cases (if programmed so during installation) arming
the system after an alarm, requires a technician code. On the
LCD display a message "Not ready-technician reset" will appear.
3
IMPORTANT!
If the alarm was caused by a tripped Smoke Detector(s), the
keypad's FIRE LED will remain lit—providing an indication that
the fire system must be reset before it will be capable of
detecting subsequent alarms. Furthermore, until reset, you will
be prevented from arming your system.
To reset smoke detector press [
] [2] [2] [user code] [ENTER]
And press [
] [
] to exit user function mode.
Summary of Contents for ORBIT-PRO RP296MUD
Page 1: ...RP296MUD User s Manual UL LISTED C L AS S A S Y S T E M...
Page 2: ......
Page 3: ...User s Manual R P 2 9 6 M U D...
Page 34: ...Notes...
