Rokonet Orbit 14 Instructions Manual Download Page 8

Page: 8 / 8

Zone Extension Wiring

Two zones can be connected to the LCD as End-of-Line supervision. Attach a 2200-ohm (or 2100 ohm) resistor to each zone

connection to the LCD. Where the zone expansion is not in use, the connection must be shorted.

Note:

If more than one keypad (whether LCD or 8-LED or 14-LED ) is connected to the panel, the total number of zone

expansions still may not exceed two. Therefore, if one zone expansion is connected to one of the keypads, only one additional

zone expansion may be connected to a second keypad. If two zone expansions are connected to one keypad, no additional

zone expansions may be used and where the zone expansion is not in use, the connection must be shorted.

Rokonet Limited Warranty

workmanship under normal use for 18 months from the date of production. Because Seller does not install or connect the product and
because the product may be used in conjunction with products not manufactured by the Seller, Seller can not guarantee the performance

of the security system whi

no other warranty, expressed or implied, and makes no warranty of merchantability or of fitness for any particular purpose.
In no case shall seller be liable for any consequential or incidental damages for breach of this or any other warranty, expressed or

charges or costs of installation or any liability for direct, indirect, or consequential damages or delay. Seller does not represent that its
product may not be compromised or circumvented; that the product will prevent any persona; injury or property loss by burglary,
robbery, fire or otherwise; or that the product will in all cases provide adequate warning or protection. Buyer understands that a properly
installed and maintained alarm may only reduce the risk of burglary, robbery or fire without warning, but is not insurance or a guaranty
That such will not occur or that there will be no personal injury or property loss as a result.
Consequently seller shall have no liability for any personal injury, property damage or other loss based on a claim that the product fails to

give warning. However, if seller is held liable, whether directly or indirectly, for any loss or damage arising from under this limited

shall be complete and exclusive remedy against seller.
No employee or representative of Seller is authorized to change this warranty in any way or grant any other warranty.
WARNING: This product should be tested at least once a week.

RTTE COMPLIANCE STATEMENT

Hereby, Rokonet Electronics Ltd, declares that this keypad (RP214KCL0XXA * ) is in compliance with the essential requirements and other relevant
provisions of Directive 1999/5/EC.

Radio Frequency Interference (Ref.: FCC Part 15, Para. 15.105)

This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced Radio/TV technician for help.

Changes or Modifications (Ref.: FCC Part 15, Para. 15.21 and 15.27)

Changes or modifications to this unit not expressly approved by Rokonet, Ltd., could void the user's authority to operate the equipment

ISRAEL

USA

ITALY

BRAZIL

Rokonet Electronics, Ltd.
Tel: +972-3-961-6555
Fax: +972-3-961-6584
e-mail: