OPERATION
Check for Engine Oil Level. Check for leaks, add oil if required.
Check for Fuel Level. Add fuel as necessary and do not overfill. Check for leaks.
Check the brakes. Depress the rear brake pedal several times, then check for proper brake
pedal free play. Make sure there is no brake fluid leakage. Adjust if necessary.
Check Tires. Check tires condition and pressure. The pressures on Front and Rear lire
are15kPa and 20kPa, respectively.
Check Drive Chain. Check for drive chain's condition and tension. Lubricate if necessary.
Check Throttle. Check for smooth operation. Assure throttle “snaps” back to idle.
Check Engine Stop Button. Perform engine stop button test Repair as necessary.
Check all Nuts, Bolts, and fasteners. Check wheels to see that all axle nuts and lug nuts are
tightened properly. Check and tighten as necessary all other fasteners to specified condition.
Check Roll Cage Bar. Ensure all protective roll cage bars are in place before operating the GO-
KART.
Check Brake Light. Check for proper operation.
Check Wheels. Cheek for tightness of wheel nuts and axle nuts. Check that axle nuts are
secured by cotter pins.
Check Steering. Check for free operation for any unusual looseness in any area.
Component locations
1.Front Tire 2.Front Shock 3.Swing Arm (Upper) 4.Brake Pedal 5.Throttle Pedal 6.Parking Brake
7.Reverse Lever 8. Seat 9.Seat Belt 10.Rear Swing Arm 11.Rear Tire 12.Rear Shock 13.Engine
Assembly 14.Water Tank 15.Fuel Tank 16,Battery 17.Auxiliary Water Tank 18.Protective Roll Cage Bar
19.Steering Wheel 20.Control Panel 21.Front light 22.Front Basket 23.Direction Machine 24.Frame
25.Turning Shore 26. Swing Arm, Front
Picture 2
2.
Pre-Drive Inspection
