rojaflex WSR-1, Original Assembly And Operating Instructions

Page: 10 / 12

3. Add wall transmitter
Press the P2 programming
button (back) 3 times on
a wall transmitter that has
already been programmed.
Upper key P2 = channel 1
Lower key P2 = channel 2
Then press the P2 program-
ming button (back) once on
the wall transmitter to be
reprogrammed.
The motor (shutter) briefly
moves UP/DOWN and/or the
receiver beeps.
OK!
First code programming suc-
cessfully performed.
SI BI
Op
en
-
Cl
os
e
UP
SI BI
Op
en
-
Cl
os
e
UP
Important:
For systems with SI (single-directional system / one-way communication), the P2
button of the already programmed wall transmitter is pressed only 2 times!
This applies, for example, to the MLSF/MLMF drives and the REHK-1 and RUE-UP external recei-
vers.
Please follow the instructions of the respective receiver/motor!
Individual deletion of hand-held or wall-mounted transmitters is NOT possible!
4. Delete wall transmitter
For further information, please refer to the instructions of the Rojaflex radio tubular motors or
radio receivers.
1. Power is ON (motor is connected and ready for operation).
2. Press P2 programming key 1 x. Motor beeps 1 x.
3. Press STOP key 1 x. Motor beeps 1 x.
4. Press P2 programming key 1 x. Motor beeps 3 x*.
OK! ALL wall (hand) transmitters are deleted!
*
The frequency of the beeps or the reaction of the motor / shutter depends on the receiver.
Please observe the corresponding instructions of the respective receiver/motor!
10
www.rojaflex.com
Programming and settings