Digital Touch Control Kettle R-7500 NEXT GEN
EN
7
•
Unwind the length of cord required to reach the mains electrical outlet. Ensure
the cord does not hang over the work surface edge
•
Remove the kettle from the base
•
Open the lid. Fill the kettle with cool water, between the MIN and MAX
markings located inside the kettle
•
Close the lid and place the kettle back onto its base, Make sure that the lid is
securely closed before boiling
Note: Always remove the kettle from its base before filling. Do not fill the kettle
above the MA X mark or below the MIN mark on the water gauge
•
Plug the kettle into the mains electrical outlet
•
Follow the instructions located in the TOUCH-CONTROLS GUIDE section.
Once you have made your touch-control selection, the kettle will sound with
two notification tones, indicating that the selected function is about to start.
The digital display will illuminate with real time temperature and count up as
the water temperature increases.
The digital display will also countdown in real time as the water temperature
decreases.
•
Note that you can stop the kettle boiling or keep warm process at any time by
pressing the POWER button
•
Should you lift the kettle from its base during a functions cycle and place it
back on to the base within 2 minutes the kettle will sound with one notification
tone and resume the pre-selected function cycle. Please do not add water into
the kettle during a boiling or keep warm cycle. Always ensure to remove the
kettle from the base before pouring.
•
When the water has boiled (without using the keep warm cycle) the kettle will
enter standby mode and its display will turn off approximately 30 seconds. To
wake the appliance, press any button.
CAUTION:
•
Never open the lid or touch its steel surfaces during boiling. Please beware of
escaping steam from the lid of the kettle when in use.
