Rohm TO-247N, User Manual

Page: 7 / 28

6/27
TO-247N(-4L) Half-Bridge Evaluation Board
User’s Guide
© 2022 ROHM Co., Ltd.
No. 63UG0
60E
Rev.001
2022.2
Table 3 Definition of power supply pins
Power supply
pin
Signal Details
T1 HVdc High-voltage input pin
The input pin during buck or inverter operation, but the output pin during boost
operation.
T2 Vsw Power source pin of H-side MOSFET and drain pin of L-side MOSFET
This pin is connected in the board and cannot be disconnected.
T3 PGND Power GND pin
Connected to SGND on the input signal side.
Table 4 Definition of signal lines
Connector Pin
No. Signal I/O Details
CN1 01 IN_H_CLK I Signal to turn on/off the H-side MOSFET. Turns on when at “H” level.
When open, it is pulled down with a 2.2 kΩ resistor.
02 SGND -- Input signal side GND. Completely separated from the DUT side GND.
CN101 01 IN_L_CLK I Signal to turn on/off the L-side MOSFET. Turns on when at “H” level.
When open, it is pulled down with a 2.2 kΩ resistor.
02 SGND -- Input signal side GND.
CN201 01 Vcc -- Power supply pin for driver IC and internal control. The gate drive power
supply is generated internally from this power supply.
02 SGND -- Input signal side GND.
JP51 01 SOURCE_HS -- PCB004P: SOURCE signal of H-side DUT.
PCB005P: DRIVER SOURCE signal of H-side DUT.
02 GND2_HS -- GND2 signal of H-side driver IC.
03 VEE_HS -- H-side negative bias power supply.
JP151 01 SOURCE_LS -- PCB004P: SOURCE signal of L-side DUT.
PCB005P: DRIVER SOURCE signal of L-side DUT.
02 GND2_LS -- GND2 signal of L-side driver IC.
03 VEE_LS -- L-side negative bias power supply.