4
/13
© 2021 ROHM Co., Ltd.
No. 63UG134E Rev.001
February.2021
User’s Guide
BD63800MUF-EVK-001
2
Safety Instructions
2.1
Warnings
▪
This evaluation kit must only be operated by trained professionals.
▪
This evaluation kit should be operated in a well ventilated environment and, if used inside a case, the case should not
be covered.
▪
This evaluation kit should be placed on a stable, flat, non-conductive surface in use and should not be contacted by
conductive items.
▪
All peripherals used with the evaluation kit should comply with relevant standards for the country of use and be marked
accordingly to ensure that safety and performance requirements are met.
▪
Where peripherals are connected that do not include the cable or connector, the cable or connector used must offer
adequate insulation and operation in order that the requirements of the relevant performance and safety are met.
▪
The connection of incompatible devices to the evaluation kit may affect compliance or result in damage to the unit and
invalidate the warranty.
2.2
Instructions for Safe Use
▪
Do not expose the evaluation kit to water, moisture or place on a conductive surface whilst in operation.
▪
Take care whilst handling to avoid mechanical or electrical damage to the printed circuit board and components.
▪
Avoid handling the printed circuit board while it is powered. Only handle by the edges to minimize the risk of electrostatic
discharge damage.
▪
Do not short any outputs to each other, to the supply or to GND.
▪
Do not operate the evaluation kit outside its specified ratings.
▪
Take care to monitor the PCB and IC temperatures in particular when operating with high power loads and do not exceed
the absolute maximum ratings of all components.
