Rohde & Schwarz ZNL Series, User Manual

Page: 48 / 240

Configuration
R&S
®
ZNL
48 User Manual 1178.5989.02 ─ 06
Conventional gating as in the Spectrum application is not available for the I/Q Ana-
lyzer; however, a special gating mode is available in remote control, see
Chap-
ter 9.4.4.2, "Configuring I/Q Gating" , on page 132.
For step-by-step instructions on configuring triggered measurements, see the
R&S
ZNL User Manual.
Trigger Source ..............................................................................................................48
└ Trigger Source ............................................................................................... 48
└ Free Run ...............................................................................................48
└ ExternalTrigger 1 ................................................................................. 49
└ IF Power .............................................................................................. 49
└ I/Q Power .............................................................................................49
└ Time ......................................................................................................49
└ Trigger Level .................................................................................................. 49
└ Repetition Interval .......................................................................................... 50
└ Drop-Out Time ............................................................................................... 50
└ Trigger Offset ................................................................................................. 50
└ Hysteresis ...................................................................................................... 50
└ Trigger Holdoff ............................................................................................... 50
└ Slope ...............................................................................................................50
Trigger Source
The trigger settings define the beginning of a measurement.
Trigger Source ← Trigger Source
Selects the trigger source. If a trigger source other than "Free Run" is set, "TRG" is dis-
played in the channel bar and the trigger source is indicated.
Remote command:
TRIGger[:SEQuence]:SOURce
on page 130
Free Run ← Trigger Source ← Trigger Source
No trigger source is considered. Data acquisition is started manually or automatically
and continues until stopped explicitly.
Trigger Settings