GUI Reference
R&S
®
ZNB/ZNBT
345
User Manual 1173.9163.02 ─ 38
5.5.1.1
Controls on the Channels Tab
The buttons in the "Channels" tab open the following dialogs:
●
Channel Manager...
: see
Chapter 5.5.1.2, "Channel Manager Dialog"
●
RFFE...
: see
Chapter 5.5.1.3, "RFFE Config Dialog for R&S
on page 348 or
Chapter 5.5.1.4, "RFFE Config Dialog for R&S
Active Channel
Selects an arbitrary channel of the active recall set as the active channel. This function
is disabled if the current recall set contains only one channel.
If one or several traces are assigned to the selected channel, one of these traces
becomes the active trace.
The order of all channels in a recall set is given by the channels' creation time. By
default, the channels are named Ch1, Ch2, ... so that Ch<n – 1> precedes Ch<n>. This
order is always maintained, even if channels are renamed, invisible (because no traces
are assigned to them) or distributed over several diagram areas.
Tip:
You can simply tap a line in the channel list to activate the corresponding channel.
Remote command:
The numeric suffix <Ch> appended to the first-level mnemonic of a command selects a
channel as the active channel.
Add Ch+Trace
Creates a new channel and a new trace, which is displayed in the active diagram area.
The new channel settings (including a possible channel calibration) are identical to the
previous channel settings; the trace is created with the trace settings of the former
active trace but displayed with another color. The former and the new active trace are
superimposed but can be easily separated, e.g. by changing the reference position
(see
Channel Config Softtool
