GUI Reference
R&S
®
ZNB/ZNBT
348
User Manual 1173.9163.02 ─ 38
CONFigure:CHANnel<Ch>:MEASure[:STATe]
INITiate<Ch>:CONTinuous
Add / Delete
The buttons below the channel table add and delete channels.
●
"Add" adds a new channel to the list. The new channel is named Ch<n>, where
<n> is the largest of all existing channel numbers plus one.
●
"Delete" deletes the channel selected in the table. This button is disabled if the
setup contains only one channel: In manual control, each setup must contain at
least one diagram area with one channel and one trace.
Remote command:
5.5.1.3
RFFE Config Dialog for R&S
ZN-B15/-Z15 Var. 02
The "RFFE Config" dialog gives access to the channel-specific setup of the two RFFE
bus interfaces and GPIO ports provided by
variant 02
of the internal/external RFFE
GPIO extension board R&S
ZN-B15/-Z15.
Access:
CHANNEL – CHANNEL CONFIG > "Channels" > "RFFE..."
If
variant 03
of the extension board is used, a different user interface is shown, see
Chapter 5.5.1.4, "RFFE Config Dialog for R&S
Background information
Refer to
Chapter 4.7.12, "RFFE GPIO Interface"
For more details about the voltage range, clock frequency ranges and their steps sizes,
refer to
Chapter 10.2.5, "RFFE - GPIO Interface "
Channel Config Softtool
