Rohde & Schwarz SMM100A, User Manual

Page: 957 / 1088

Remote control commands
R&S
®
SMM100A
957 User Manual 1179.1341.02 ─ 05
Parameters:
<Logarithmic> float
The unit is mandatory.
Range:
0.01 to 100
Increment: 1E-3
*RST:
1
Default unit: PCT
Example: See Example "Setup an RF frequency or power sweep"
on page 950.
Manual operation: See "Step Linear/Step Logarithmic" on page 342
[:SOURce<hw>]:SWEep[:FREQuency]:STEP[:LINear] <Linear>
Sets the step width for linear sweeps.
See Chapter 7.10.2.1, "Correlating parameters in sweep mode" , on page 329.
Omit the optional keywords so that the command is SCPI-compliant.
Parameters:
<Linear> float
Range:
0.001 Hz to (STOP - STARt)
Increment: 0.01
Example: See Example "Setup an RF frequency or power sweep"
on page 950.
Manual operation: See "Step Linear/Step Logarithmic" on page 342
[:SOURce<hw>]:COMBined:FREQuency:STARt <CombFreqStart>
Sets the start frequency of the combined RF frequency / level sweep.
See Chapter 7.10.2.1, "Correlating parameters in sweep mode" , on page 329.
Parameters:
<CombFreqStart> float
Range:
-59999E5 to 12E9
Increment: 0.01
*RST:
100E6
Example: See Example "Setup an RF frequency or power sweep"
on page 950.
[:SOURce<hw>]:COMBined:FREQuency:STOP <CombFreqStop>
Sets the end frequency of the combined RF frequency / level sweep.
SOURce subsystem