Rohde & Schwarz SMM100A, User Manual

Page: 397 / 1088

Configuring the RF signal
R&S
®
SMM100A
397 User Manual 1179.1341.02 ─ 05
2. If you already have created a file with user correction data:
a) Select "UCOR Data > navigate to the file *.uco > Select".
b) Proceed with
step 4 .
3. If you need to create a file:
a) Select "UCOR Data > New".
b) Enter the filename
UCOR_Data
and confirm with "Ok".
c) Choose the file and confirm with "Select".
d) Select "Edit UCOR Data".
e) To fill the user correction data table, proceed as described in
Chapter 7.12.3,
"User correction" , on page 394.
4. Select block diagram > RF > "On".
5. Select "State > On".
The "UCOR" dialog contains all settings for creating and handling files with user-
defined level correction values.
The remote commands required to define these settings are described in Chap-
ter 13.16.5, "SOURce:CORRection subsystem" , on page 875.
Settings
State ............................................................................................................................397
User Correction ........................................................................................................... 398
UCOR Data ................................................................................................................. 398
Edit UCOR Data ..........................................................................................................398
State
Activates user correction.
The R&S SMM100A displays the status icon "Lev Ucor" in the status bar.
User correction cannot be activated simultaneously with absolute level compensation
based on user-defined frequency response values. These functions exclude each
other; you can one only of them at a time.
See user manual R&S SMM-K544 User-Defined Frequency Response Correction.
Improving level performance