Rohde & Schwarz SMBV100B, User Manual

Page: 515 / 1030

General Instrument Functions
R&S
®
SMBV100B
513 User Manual 1178.4460.02 ─ 03
Power-On/EMF settings
Access:
► Select "RF" > "RF Level" > "Power-On / EMF".
The "Power-On/EMF" dialog contains all settings for configuring the power-on
behavior and the level display.
Settings:
Power-On State ..........................................................................................................513
Display Level as Voltage of EMF ............................................................................... 513
Power-On State
Determines the RF signal output state when the instrument is switched on.
You can disable the RF output signal in general, or start it in the same state as it had
been when it was switched off.
Remote command:
:OUTPut<hw>[:STATe]:PON
on page 647
Display Level as Voltage of EMF
Activates display of the signal level as voltage of the EMF (no-load voltage).
If disabled, the level is displayed as a voltage over a 50 Ohm load.
Note:
The setting is not affected by an instrument preset ([Preset] key or
*RST
) and the
"Save/Recall" function. It is reset only by factory preset.
Remote command:
[:SOURce<hw>]:POWer:EMF:STATe
on page 870
10.1.5 How to Set the Initial Instrument Settings
This section describes how to set up the R&S SMBV100B initially.
10.1.5.1 Setting the Keyboard Language
You can select the language of the external keyboard connected to the instrument.
To adjust the keyboard settings
1. Press the [Setup] key.
Customizing the User Interface