Rohde & Schwarz SMBV-P101, User Manual, Page: 33 / 131

GNSS Production Configuration and Settings
R&S
®
SMBV-P101
18 User Manual 1176.9787.02 ─ 05
●
Additionally, you can access settings for configuring the satellite signals.
The remote commands required to define these settings are described in Chapter 6,
"Remote-Control Commands" , on page 58.
● General Settings for GNSS Simulation ................................................................... 18
● Navigation Data .......................................................................................................21
4.1.1 General Settings for GNSS Simulation
To access these settings:
► Select "Baseband > Satellite Navigation > GNSS Production Tester".
The provided settings enable you to perform general configurations, like to set the
default settings or access further dialogs.
State
Activates GNSS signal generation. A continuous GNSS signal is generated for four
satellites in real time mode.
Note: Enabling the standard sets the "Frequency" and "Level" values in the status bar
of the instrument according to the selected "RF Band" and "Total Power" at the simula-
tion start time.
Remote command:
[:SOURce<hw>]:BB:GNPR:STATe
on page 59
Set to default
Calls the default settings. The values of the main parameters are listed in the following
table.
Note: Use Update RF Frequency function to preset the RF Frequency and level.
Parameter Value
State Not affected by "Set to default"
RF Band L1/E1
Almanac GPS_SEM678.txt/GAL_Yuma678.txt/GLO_678.agl/
Beidou_Yuma678.txt
GNSS Main Dialog