Preparing for use
R&S
®
SGT100A
21
Getting Started 1419.4576.02 ─ 10
To prevent RF output switch-off
►
NOTICE!
If you set a too high output level without a load connected to the
instrument, the reverse power can exceed a limit forcing the R&S
SGT to
switch off the RF output.
Connect a load with sufficient return loss.
4.9
Connecting to non-screwable connectors
Non-screwable connectors of the R&S
SGT are BNC type connectors on the
.
► To connect the RF cable with the RF
50
Ω
connector, proceed as follows:
a) Carefully align the connector of the cable and the RF
50
Ω
connector along
a common axis.
b) Mate the connectors along the common axis until the male pin of the con-
nector of the cable engages with the female socket of the RF
50
Ω
connec-
tor.
4.10
Switching on or off
The following table provides an overview of power states, LEDs and power switch
positions.
Table 4-2: Overview of power states
State
LED
Position of power switch
Off
gray
[0]
Standby
orange
[I]
Ready
green
[I]
To switch on the R&S
SGT
The R&S
SGT is off but connected to power. See
1. Set the switch on the power supply to position [I].
Switching on or off
