Instrument tour
R&S
®
SGT100A
35
Getting Started 1419.4576.02 ─ 10
Pressing the [LAN] key resets the network settings, e.g., "IP Adress Mode" is
reset to "DHCP".
Table 5-4: Overview of LAN connection states
[LAN] state
LED
Remark
Connected
green
Connected to the network.
Running process
blinking orange
Resets the network settings, applies the default set-
tings.
Error
red
Network error occurred.
Off
gray
The internal reference signal is used.
How to:
●
Chapter 4.7, "Connecting to LAN"
●
Chapter 4.13.2, "Connecting a remote PC via LAN"
[ID]
The [ID] key allows you to identify your R&S
SGT, e.g. in complex test setups with
more instruments.
The following applies if the R&S
SGT is connected to a remote controller with
R&S
SGMA-GUI installed:
●
Press the [ID] key identify your R&S
SGT on the remote controller. In the dia-
log "SGMA-GUI > Setup > Instruments > Configure Instruments > Edit Instru-
ment", the R&S
SGT is active.
●
Set "Edit Instrument > Device Identify > On" to identify your R&S
SGT from
the remote controller. The LED of the [ID] key is orange and blinking.
Table 5-5: Overview of [ID] key states
[ID] state
LED
Remark
Identification
blinking orange
Identification of the R&S
SGT.
Off/Inactive
gray
No identification.
5.2
Rear panel tour
This section provides an overview of the connectors on the rear panel of the
instrument. For technical data of the connectors, refer to the data sheet.
Rear panel tour
