Preparing for use
R&S
®
SGT100A
18
Getting Started 1419.4576.02 ─ 10
●
Use the cable R&S
SMU-Z6 for connection to the "DIG I/Q" interface of the
instrument. The cable is available under material number 1415.0201.02.
Signal input and output levels
Information on signal levels is provided in the data sheet. Keep the signal levels
within the specified ranges to avoid damage to the R&S
SGT and connected devi-
ces.
Preventing electrostatic discharge (ESD)
Electrostatic discharge is most likely to occur when you connect or disconnect a
DUT.
►
NOTICE!
Electrostatic discharge can damage the electronic components of
the product and the device under test (DUT).
Ground yourself to prevent electrostatic discharge damage:
a) Use a wrist strap and cord to connect yourself to ground.
b) Use a conductive floor mat and heel strap combination.
4.6
Connecting to power
For safety information, see
1. Plug the AC power cable into the AC power connector on the rear panel of the
instrument. Only use the AC power cable delivered with the R&S
SGT.
2. Plug the AC power cable into a power outlet with ground contact.
The required ratings are listed next to the AC power connector and in the data
sheet.
There is no need to set the voltage manually or change fuses.
Connecting to power
