Rohde & Schwarz R&S UPP, User Manual

Page: 289 / 938

Instrument Functions
R&S
®
UPP
273 User Manual 1411.1055.32 ─ 10
Track to other channels
"Deactivated:" The "Channel" parameter field underneath it can be edited, and the
change of a parameter underneath it exclusively affects the channel
identified by "Channel".
"Activated:" At the time of switching from deactivated to activated, all parameters
of the currently displayed channel are copied to all the other chan-
nels. So, identical data sets are present for all 8 channels. The
"Channel" parameter field underneath it is no longer editable. A
change in one of the parameters underneath no longer affects an
individual channel, but
all 8 channels at the same time .
Remote command:
SOURce:SCHSettings:TTOChannels
on page 715
Channel
This parameter field is editable if the "Track to other channels" parameter field above it
is deactivated.
The value designates one of 8 channels whose parameter set is displayed below
"Channel" in the panel. Changes to these parameters concern only the channel indica-
ted here. Changing the number in this field allows a
quick overview of the parameters
of all channels.
Remote command:
SOURce:SCHSettings:CHANnel
on page 715
Filter
The overall signal is filtered in the time domain. One of the user
‑
definable filters in the
Filter panel or a weighting filter can be selected. All level settings apply to the unfiltered
signal.
Remote command:
SOURce:MCHannel<n2>:FILTer
on page 776
For a description of the filters and their setting parameters, see Chapter 5.39.4, "Filter
Table" , on page 468.
Sine
The channel-based sine-wave signal is generated based on the parameter fields "Fre-
quency", "Phase" and "Voltage" underneath it and added to the overall signal.
The checkbox enables or disables this function.
Generator Signals