Rohde & Schwarz OSP-B200S2, User Manual

Page: 270 / 327

RC Commands
R&S
®
OSP
270 User Manual 1178.7100.02 ─ 05
Parameters for setting and query:
<channel list> <expr>
List of external transfer relays (connected to module R&S
OSP-
B104) and associated delay times to be set or queried.
(@FxxMyy(sssee))
Defines the channel list for one relay with the following parame-
ters:
FxxMyy: as described in
ROUTe:CLOSe
on page 253.
sss
= 0 to 255. The digits in front of the last 2 digits (hence, the
1, 2 or 3 leading digits in the parenthesis) represent the 8-bit
delay value. The adjustable delay time has a resolution of 50
ms
and spans from 0 to 12.75 seconds (255 x 50 ms = 12750 ms).
The default value 2 is equivalent to a delay time of 100 ms.
ee
= 11, 12, 13, 14. The last 2 digits in the parenthesis represent
the numbers ("names") of the relays (up to 4) that are connected
to the R&S
OSP-B104. The numeral offset of 10 distinguishes
these relay numbers from the I/O channel numbers 01 to 04 on
the same module.
Range:
0 to 255, equivalent with 0 ms to 12750 ms
Increment: 1 = 50 ms
*RST:
2 = 100 ms
For more channel list details, refer to the description of the
ROUTe:CLOSe
command.
Example: Setting :
CONF:REL:DEL (@F01M11(611:614))
All four relays (K11, K12, K13, K14) connected to the module at
position
M11
in the switch unit with ID
F01
are configured to a
delay time of 6 * 50 ms = 200 ms to change their states.
Example: Query :
CONF:REL:DEL? (@F01M11(11:14))
Return values:
4,4,4,4
In the rear parenthesis of the query's channel list, enter only the
two-digit relay names and omit any leading delay-value digits.
The
return values are only the delay time settings of the queried
relays. In this example, all delay times are 4 * 50 ms.
CONFigure:ALL:BACKup <backup filename>
Saves all configuration settings to a backup file. These settings comprise the following:
●
General configuration
●
Network settings
●
Trigger configuration (optional)
●
Interconnection configuration
●
Virtual configuration
All configuration filenames have the extension "
.backup
". Do not enter the extension
when specifying a filename. A filename query does not return the extension.
CONFigure Commands