Remote control commands
R&S
®
NRPM
163
Mannual 1425.8663.02 ─ 08
Usage:
Query only
[SENSe<Sensor>:]TRACe:MPWidth?
Queries the attainable time resolution of the trace mode. The result is the small-
est possible distance between two pixels, i.e. it is the smallest time interval that
can be assigned to a pixel.
Usage:
Query only
[SENSe<Sensor>:]TRACe:OFFSet:TIME
<time>
Sets the relative position of the trigger event in relation to the beginning of the
trace measurement sequence. It is used to specify the start of recording for trace
mode.
The start of recording is referenced to the delayed trigger point that is set with
. Negative values indicate that the start of recording occurs
before the trigger point.
Parameters:
<time>
Range:
-3.0 to 3.0
*RST:
0.0
Default unit: s
Manual operation:
[SENSe<Sensor>:]TRACe:POINts
<points>
Sets the number of required values per trace sequence.
Parameters:
<points>
Range:
1 to 100000
*RST:
260
Manual operation:
[SENSe<Sensor>:]TRACe:REALtime
<state>
Activates realtime processing of the trace mode.
Configuring the measurement modes
