4
Subject to change without notice
1 Introduction
The HZO5 current probe has been designed for use with
multimeters and oscilloscopes respectively for accurate,
non-intrusive measurement of AC, DC and complex wave-
form currents.
Using advanced Hall Effect technology the HZO5 can measu-
re currents accurately with a resolution of 00 mA/500 mA
from 500 mA to 000 Amps over the frequency range of DC
to 0 kHz.
These features make it a powerful tool for use in inverters,
switch mode power supplies, industrial controllers and other
applications requiring current measurement and/or wave-
form analysis.
2 Safety
The following symbols appear on the products:
Warning
The HZO51 may only be used and handled by qua-
lified personnel. To avoid personal injury, follow
these precautions:
– To avoid electric shock, use caution during installation
and use of this product; high voltages and currents may
be present in circuit under test.
PN 2560394
March 2006
©2006 Fluke Corporation. All rights reserved.
®
i30s/i30
AC/DC Current Clamps
Instruction Sheet
Introduction
The i30s AC/DC Current Clamp has been designed for use with
oscilloscopes and DMMs for accurate, non-intrusive
measurement of both AC, DC, and complex waveform currents.
The i30 AC/DC Current Clamp has been designed for use with
DMMs only. Using advanced Hall Effect technology the i30s can
accurately measure currents with a resolution of 1 mA from 5 mA
to 30 A over the frequency range of DC to 100 kHz. These
features make it a powerful tool for use in inverters, switch mode
power supplies, industrial controllers and other applications
requiring current measurements and/or waveform analysis.
Symbols
The table below lists the symbols used on the product and/or in
this manual.
Symbol
Description
c
Do not dispose of this product as unsorted municipal
waste. Contact Fluke or a qualified recycler for
disposal.
<
Important Information. See manual.
9
Double insulation.
Do not apply around or remove from the HAZARDOUS
LIVE conductors.
Conforms to Canadian Standards Association.
5
Complies with the relevant European standards.
Do not dispose of this product as unsorted municipal
waste. Contact HAMEG Instruments GmbH or a
qualified recycler for disposal.
PN 2560394
March 2006
©2006 Fluke Corporation. All rights reserved.
®
i30s/i30
AC/DC Current Clamps
Instruction Sheet
Introduction
The i30s AC/DC Current Clamp has been designed for use with
oscilloscopes and DMMs for accurate, non-intrusive
measurement of both AC, DC, and complex waveform currents.
The i30 AC/DC Current Clamp has been designed for use with
DMMs only. Using advanced Hall Effect technology the i30s can
accurately measure currents with a resolution of 1 mA from 5 mA
to 30 A over the frequency range of DC to 100 kHz. These
features make it a powerful tool for use in inverters, switch mode
power supplies, industrial controllers and other applications
requiring current measurements and/or waveform analysis.
Symbols
The table below lists the symbols used on the product and/or in
this manual.
Symbol
Description
c
Do not dispose of this product as unsorted municipal
waste. Contact Fluke or a qualified recycler for
disposal.
<
Important Information. See manual.
9
Double insulation.
Do not apply around or remove from the HAZARDOUS
LIVE conductors.
Conforms to Canadian Standards Association.
5
Complies with the relevant European standards.
