Rohde & Schwarz FE50DTR, Manual

Page: 32 / 46

Operating the instrument
R&S
®
FE50DTR
32 Manual 1179.3180.02 ─ 02
Test setup
DUT
RF shield box
Vector signal
generator
RF
Ref Out Ref
LAN
IF In B RF B
Ref In
LAN
RF Out
R&S
FE50DTR
LAN
IF In
The following step-by-step descriptions use an R&S SMW as vector signal gener-
ator.
●
"To connect the R&S FE50DTR for Tx mode" on page 32
●
"To control the R&S FE50DTR with a vector signal generator" on page 33
●
"To configure frequency settings at the vector signal generator" on page 35
If supported, the descriptions for other Rohde & Schwarz vector signal generators
are analogous.
To connect the R&S FE50DTR for Tx mode
The R&S FE50DTR is connected to power and switched on .
► Connect all connectors for connections between the R&S FE50DTR and
R&S SMW, and R&S FE50DTR (RF Out) and DUT as in Table 6-2 .
Table 6-2: Signals and connections in Tx mode
Signal Vector signal generator
e.g, R&S
SMW
R&S FE50DTR
Reference Connector "REF OUT"
Frequency: 1
GHz, 10 MHz
"Ref In"
LAN (Control) "LAN" "LAN"
IF In "RF A"/"RF B" "IF In B"
RF Out - "RF B"
How to:
●
Chapter 4.7, "Connecting to LAN" , on page 16
● Chapter 4.8, "Connecting to SMA and 1.85 mm" , on page 17
Operating the R&S FE50DTR in Tx mode