Rohde & Schwarz ESW Series, User Manual

Page: 675 / 759

Remote Commands in the Receiver Application
R&S
®
ESW
675 User Manual 1177.6298.02 ─ 08
Parameters:
<arg0> string
Example: SYST:PASS:CEN '894129'
Manual operation: See "Password" on page 346
15.10 Using the Status Register
For more information on the contents of the status registers see:
●
"STATus:OPERation Register" on page 383
●
"STATus:QUEStionable:ACPLimit Register" on page 385
●
"STATus:QUEStionable:EXTended Register" on page 386
●
"STATus:QUEStionable:FREQuency Register" on page 387
●
"STATus:QUEStionable:LIMit Register" on page 388
●
"STATus:QUEStionable:LMARgin Register" on page 388
●
"STATus:QUEStionable:POWer Register" on page 389
●
"STATus:QUEStionable:TIMe Register" on page 390
● General Status Register Commands .................................................................... 675
● Reading Out the CONDition Part .......................................................................... 676
● Reading Out the EVENt Part .................................................................................676
● Controlling the ENABle Part ..................................................................................677
● Controlling the Negative Transition Part ............................................................... 678
● Controlling the Positive Transition Part ................................................................. 678
15.10.1 General Status Register Commands
STATus:PRESet
.............................................................................................................675
STATus:QUEue[:NEXT]?
................................................................................................ 675
STATus:PRESet
This command resets the edge detectors and
ENABle
parts of all registers to a defined
value. All
PTRansition
parts are set to
FFFFh
, i.e. all transitions from 0 to 1 are
detected. All
NTRansition
parts are set to 0, i.e. a transition from 1 to 0 in a
CONDition
bit is not detected. The
ENABle
part of the
STATus:OPERation
and
STATus:QUEStionable
registers are set to 0, i.e. all events in these registers are not
passed on.
Usage: Event
STATus:QUEue[:NEXT]?
This command queries the most recent error queue entry and deletes it.
Using the Status Register