V L F
>
H F R E C E I V E R S
f
E K 8 9 5 / E K 8 9 6
Operator Manual
Definitions
BIT
In the BIT (built
>
in test) it is checked whether all modules of
the basic unit are installed and operative. If required, error
messages are output which may also inform on the operating
status of the installed options. In addition, the Tx and Rx paths
are checked. The BIT is initiated either through switch
>
on or on
purpose during operation by pressing softkey BIT in the MAIN
menu.
CM
In CM (continuous monitoring) all important equipment
functions are permanently monitored. This check is automatic.
Error messages are output following which the operator can
initiate the BIT to localize the fault.
6075.6991.82.01
>
B.1 / B.2
>
