GUI Reference
R&S
®
CMW-B400B/-B405A
46
User Manual 1176.8116.02 ─ 04
Configure this setting according to the maximum voltage that you want to generate, for
example the maximum voltage expected by a connected external audio analyzer.
Remote command:
CONFigure:AUDio:SPEech<i>:ANALog:OLEVel
Clock Drift
Adjusts the clock of the audio board, used for A/D and D/A conversions.
The value is entered in parts per million (ppm). A positive value accelerates the clock.
A negative value slows it down.
The checkbox enables/disables the clock adjustment.
Remote command:
CONFigure:AUDio:SPEech<i>:CDRift
High Pass
Configures the cutoff frequency of a highpass filter, located between the AF input con-
nectors and the speech encoder. This setting is only displayed, if the speech codec is
connected to AF connectors.
Remote command:
CONFigure:AUDio:SPEech<i>:ANALog:FILTer:HPASs
4.6 Additional Softkeys and Hotkeys
The "Speech Analysis" tab of the audio measurement provides softkeys that are rela-
ted to the currently selected controlling master application.
While one of the softkeys is selected, the "Config" hotkey opens the configuration dia-
log of the controlling application, not the configuration dialog of the measurement.
The softkeys are described in the following.
Signaling Parameter > ...
Provides hotkeys for access to the most essential settings of the controlling applica-
tion.
Remote command:
Use the commands of the controlling application.
... Signaling
Select this softkey and press ON | OFF to turn the downlink signal transmission on or
off.
Press the softkey two times (select it and press it again) to switch to the controlling
application.
Remote command:
Use the commands of the controlling application.
Additional Softkeys and Hotkeys
深圳德标仪器
135-1095-0799
