Rohde & Schwarz AREG100A, User Manual, Page: 62 / 321

Radar Echo Generation
R&S
®
AREG100A
62 User Manual 1178.7417.02 ─ 04
Remote command:
[:SOURce<hw>]:AREGenerator:RADar:OTA:OFFSet
on page 248
Source
The R&S AREG100A is equipped with an internal reference oscillator that generates a
reference frequency of 10 MHz. It is used as internal reference source for the synthe-
sizer.
Alternatively, you can apply an external reference signal.
Regardless of the used reference source (internal or external), the R&S AREG100A
always outputs the reference frequency at the output connector. You can use it, for
example to synchronize further connected instruments.
Internal Uses the internal reference oscillator
External Uses an external reference frequency signal.
Remote command:
[:SOURce]:ROSCillator:SOURce
on page 243
4.2.5 Power Sensors
For details, see Chapter 5, "Using Power Sensors" , on page 63.
Sensor ...........................................................................................................................62
Eirp ................................................................................................................................62
Sensor
Displays connected sensors.
Eirp
Displays the measured EIRP value of the radar sensor. The EIRP value of the radar
sensor is calculated with the measured output power of the radar sensor, AREG
antenna gain, air gap. AREG internal gains and temperature compensation.
Remote command:
[:SOURce<hw>]:AREGenerator:RADar:EIRP?
on page 248
GUI Elements