Rohde & Schwarz 6144.7800.02, Operating Manual

Page: 157 / 189

R&S EU4200C Troubleshooting
6174.8456.02-01 4.4
4.2 Troubleshooting
Troubleshoot ing\Tro ublesho oting " Radio". doc
CBIT events
If an event occurs on the radio, it will be stored in the event log of the radio.
The event log can be read out via LAN interface or using the Service and
Maintenance Tool R&S ZS4200. The following chapters give an overview
about all the possible CBIT events.
Note:
In most cases of error, the receiver will need to be transferred to the
nearest service.
Description of
columns
Column Description
Code
Code
is the unique number for this kind of event.
Message
Message
is the designation of this event.
Level
Level
is a ranking of this event (W = warning; E = error;
— = information). Warnings and errors will be logged into
CBIT status list and Event List. Errors and NOGO
warnings additionally cause NOGO (LED GO not
illuminated, error code 102). Information are only logged
into Event List.
Config
Config
states the configurability of each event:
W = event can be configured as warning,
N = event can be configured to cause NOGO.
Notes
Notes
describes the reasons and if necessary the
reaction of the radio when the event occurs.
Action
Action
describes what the user can do to eliminate the
cause of the event.
4.2.1 RX CBIT Events
Code Message Level Config Note Action
0101 INACTIVE WARNING W W Radio was switched to
the inactive mode, e.g.
via the *OFF contact on
the rear panel or by
software command or
locally on the radio (see
chapter 3.4.7.2).
If the radio switches
into INACTIVE mode,
all active VoIP
connections will be
terminated and new
VoIP connection
requests will be
rejected.
Check the Vop LED (see
chapter 4.1.2).
Check the hardware
input *OFF on connector
X10.7.
Check software settings.