Preparing for use
R&S
®
RTP
24
Getting Started 1803.6478.02 ─ 01
All current settings are saved, and the software shuts down. The [Power] key
turns orange. The standby power supplies only the power switch circuits.
The "Exit" icon in the "Menu" shuts down only the firmware application. To shut
down the instrument completely, use the [Power] key.
To disconnect from power
The product is in the standby state.
1.
NOTICE!
Risk of data loss. If you disconnect the product from power when it
is in the ready state, you can lose settings and data. Shut it down first.
Set the switch on the power supply to position [0].
The LED of the [Power] key is switched off.
2. Disconnect the product from the power source.
4.8
Connecting external devices
The following interfaces for external devices are provided:
●
USB connectors at the front and rear panel of the instrument
●
Monitor connectors HDMI and DisplayPort at the rear panel of the instrument
4.8.1
Connecting USB devices
You can connect USB flash drives to save screenshots and measurement results,
and keyboard and/or mouse to simplify the operation and the entry of data. You
can connect or disconnect all USB devices during operation of the instrument.
The number of USB connectors can be increased by using USB hubs.
USB devices are plug&play, the operating system automatically uses the suitable
device driver. If the operating system does not find a suitable driver, it prompts
you to specify a directory that contains the driver software. If the driver software is
on a storage media, connect the appropriate drive to the instrument before pro-
ceeding. If the instrument is integrated in a network, you can also install driver
data stored in a network directory.
Connecting external devices
