Rohde & Schwarz 1424.7805K02, User Manual

Page: 115 / 530

Sensor configuration
R&S
®
NRX
115 User Manual 1178.5566.02 ─ 09
7 Sensor configuration
Access: "Measurement Settings" > "Primary Sensor Config" or "Secondary Sensor
Config"
You can define two sensor configurations in parallel, a primary and a secondary sensor
configuration. To these configurations, you can assign a sensor that is connected to
one of the sensor ports of the R&S NRX. These sensors are called primary sensor and
secondary sensor.
Further information:
●
"Primary Sensor, Secondary Sensor" on page 70
●
Chapter 6, "Measurement and display configuration" , on page 52
●
Chapter 13.8.6, "Standardized signals" , on page 351
● Mode settings ........................................................................................................ 115
● Correction settings ................................................................................................ 119
● Filter settings .........................................................................................................122
● Range settings ...................................................................................................... 126
● NRT measurement type ........................................................................................ 128
7.1 Mode settings
Access:
"Measurement Settings" > "Primary Sensor Config" > "Mode"
"Measurement Settings" > "Secondary Sensor Config" > "Mode"
Available for all measurement types.
Mode settings