Instrument tour
R&S
®
NRX
24
Getting Started 1424.7070.02 ─ 09
Sensor connectors A and B are used to connect the R&S
NRP power sensors
and the R&S
NRQ6. For details on the supported power sensors, see the data
sheet.
The complete functional range, including external trigger and reference clock for
the synchronization of connected sensors, is provided by these connectors.
Further information:
●
Chapter 4.7, "Connecting power sensors"
5.1.2
Module bay
See (1) in
.
Two options fit in this bay. If you have both options, you can exchange them, see
If no option is installed, the module bay is closed by a cover.
Sensor check source (R&S NRX-B1)
Used as a power reference for testing the connected power sensors and the
cabling. The LED of the sensor check source (R&S NRX-B1) shows the state,
see
You can remove the option and send it to Rohde & Schwarz for calibration. Con-
tact the Rohde & Schwarz customer service.
Table 5-1: Possible states
Illumination
State
Signal output setting
Off
No signal is generated.
"Off"
Steady green
Continuous wave is output.
"CW"
Blinking green Pulse signal is output.
"Pulse"
Blinking red
Settings conflict exists.
For example if "Pulse" is set and the
power level is set to 20
dBm.
"CW" or "Pulse"
Interface for R&S NRT-Z sensors (R&S NRX-B9)
Provides an optional power sensor interface to connect an R&S
NRT
‑
Zxx power
sensor. For supported power sensors, see the data sheet.
Front panel tour
