Preparing for use
R&S
®
NRX
20
Getting Started 1424.7070.02 ─ 09
4 = port
2 (RF connector)
5 = load
6 = host interface connector
To connect the R&S
NRT
‑
Zxx directional power sensor
Connect the R&S
NRT
‑
Zxx directional power sensor between source and load of
your test setup as follows.
1. Connect RF connector (2, port
1) to the source.
a) Insert RF connector (2) straight into the RF connector of the source. Take
care not to tilt the R&S
NRT
‑
Zxx directional power sensor.
b) Tighten the RF connector securely by hand.
2. Connect RF connector (4, port
2) to the load.
a) Insert RF connector (4) straight into the RF connector of the load. Take
care not to tilt the R&S
NRT
‑
Zxx directional power sensor.
b) Tighten the RF connector tightly by hand.
During the measurement, the RF power flow can be high. Power leakage
has the risk of electric shock and severe skin burns.
3. Connect the host interface connector of the R&S
NRT
‑
Zxx directional power
sensor (6) to the interface for R&S NRT-Z sensors (R&S NRX-B9).
To disconnect the R&S
NRT
‑
Zxx directional power sensor
1.
CAUTION!
Risk of electric shock and severe skin burns. During the measure-
ment, the RF power flow can be high.
Switch off the RF power before touching the RF connectors.
2. Unscrew the RF connectors by hand.
3. Disconnect the cable of the R&S
NRT
‑
Zxx directional power sensor (6) from
the interface for R&S NRT-Z sensors (R&S NRX-B9).
4.7.3
LAN interface
See
Chapter 5.2.2, "Ethernet interface"
Suitable for LAN power sensors.
Connecting power sensors
