Notes on Safety
R&S
®
RT-ZC10
7
User Manual 1409.7808.02 ─ 03
Risk of fatal injury
●
This device is made for use with the R&S
RT-ZA13 probe power supply.
●
When using a measurement instrument that does not provide isolation
between its input terminals and chassis or other input terminals, please
pay attention to the following points. If a signal is applied to an input ter-
minal other than that to which this device is connected, do not connect
the ground-side terminal to any nonground potential. Otherwise, short-
circuit current flows through the R&S
RT-ZA13 probe power supply, or
this device from the ground terminal, which could cause an electrical
accident or damage.
Shock hazard
Do not allow the device to get wet, and do not take measurements with wet
hands. This may cause an electric shock.
To avoid electric shock when measuring live lines, wear appropriate protec-
tive gear, such as insulated rubber gloves, boots, and a safety helmet.
