7)
Matching Speaker Impedance
- The Rogue 88 provides options
for either 4 ohm or 8 ohm speakers. The impedance selected will
depend on the speakers used. Consult either the owner’s manual
for your speaker or your local dealer for the correct choice. To
switch impedance setting, refer to figures 5 and 6. Note - the
amplifier is factory set for 8-ohm speakers.
⇒
Using a 5/16” wrench, remove the outermost nut from the
red binding post.
⇒
Remove the wire and lug marked 8 ohm from the binding
post. Leave the wire and lug marked feedback in place.
Warning-Never remove the lugs marked feedback or ground from the
binding posts. Doing so could cause permanent damage to the unit
⇒
Remove the polyurethane tubing from the unused 4-ohm
wire and lug.
⇒
Place 4-ohm wire and lug onto red binding post.
⇒
Place polyurethane tubing on the 8-ohm wire and lug.
⇒
Replace nut onto binding post and tighten with wrench.
8)
Attach Power Cord -
Connect the IEC end of detachable power
cord to the amplifier, and plug opposite end into corresponding
outlet.
9)
Connections to other components
-. The input connections from
the preamplifier are made via RCA jacks on the rear of the
amplifier. Be sure to use high quality interconnect cables - they
do make a difference.
Rogue Eighty-Eight Owners Manual
6
Binding Post
Connections
Figure 5
Figure 6
Rogue Eighty-Eight Owners Manual
7
