Roger SL2000H, Manual

Page: 2 / 11

Security Lock SL2000H v1.0 EN Rev.C.doc 2011-11-16
Page 2 of 11
Features
 Door Lock output to control door locking device
 Status output to signal current working mode: Armed or Disarmed
 Alarm output to indicate Door Bell and Door Alarm
 Door Contact input for detection of door status
 Exit Button input to unlock the door from the external button
 INSTALLER code for programming
 MASTER code switch between armed and disarmed modes
 USER codes for door unlocking
 Programmable length of codes
 User indexing for easy administration of the codes
 Nonvolatile memory
 Metal enclosure, outdoor operation
 Three LEDs and buzzer
 Tamper
 12VDC supply
 CE
Introduction
The SL2000H electronic code lock is dedicated to operate as a stand-alone door access
control unit. It is equipped with one relay output, two transistor outputs and three inputs.
All codes and parameters programmed to device are stored in nonvolatile memory.
SL2000H have metal cover and outdoor operation available.
Functional Description
Outputs
SL2000H has one relay output (REL1) and two transistor outputs (OUT1 and OUT2). The
REL1 and OUT1 outputs can be configured to operate in one of two modes:
Door Lock or
Status . The OUT2 has fixed function and is always assigned to signal Door Bell and
Door Alarm states. The REL1 output offers one switched NO/NC contact rated 1.5A/30V
AC/DC. The OUT1 and OUT2 lines are open collector transistor lines which normally
remain in high resistance state however when triggered they short to supply minus. The
OUT1/2 transistor output can sink up to 50mA DC while maximum voltage applied to it
must be 15V or less. Both transistor outputs are internally protected against overload. By
default, in factory new device the REL1 is configured to work in the
Door Lock
(momentary) mode while OUT1 works in Status (latch) mode. This settings can be
changed whenever required using JP3, JP4, JP5 and JP6 jumpers (for details see
diagrams in section:
Installation later in this document). The actual state of REL1 output
is signaled on LED OPEN (green) which lights up as long as REL1 output is active. The
OUT1 line is signaled on dual color LED STATUS which lights up in red when output is
OFF and green when it is ON.
Note: The C1,C2…C10 parameters which appear in this manual refer to the configuration
parameters programmed to the SL2000 during Memory Reset procedure (for details see
section: Configuring the SL2000 later in this document).