MCX4D Operating Manual.doc
2018-07-20
10/15
604
Object DR2 comment
as above
605
Object DC3 comment
as above
606
Object DR3 comment
as above
607
Object DC4 comment
as above
608
Object DR4 comment
as above
Output comments
651
Object LCK1 comment
as above
652
Object BELL1 comment
as above
653
Object LCK2 comment
as above
654
Object BELL2 comment
as above
655
Object LCK3 comment
as above
656
Object BELL3 comment
as above
657
Object LCK4 comment
as above
658
Object BELL4 comment
as above
Device configuration
The expander is configured within low level configuration by means of RogerVDM software. The address of
expander can also be programmed manually within memory reset procedure
Fig. 8 Connection of expander to RUD-1 (configuration)
Memory reset:
Turn power supply off
Place jumper on MEM pins
Connect LCK1 and DC1 terminals
Turn power supply on
When device is supplied then LED AC shall pulsate quickly
Disconnect LCK1 and DC1 terminals
Count the number of LED AC pulses and press RES button when the number corresponds to
required address
Remove jumper from MEM pins
