EN
56
11
Commands and Accessories
If not installed, safety devices with NC contacts must be jumpered at the COM terminals, or disabled by modifying
the parameters
,
,
,
,
and
.
/)=
N.A. (Normally Open) .
N.C. (Normally Closed).
CONTACT
DESCRIPTION
9 (COR) 10
Output (potential free contact) for connecting courtesy light.
:EG;:EG
HG;ƼK
12(LAM) 11(COM)
'SRRIGXMSRJSVƽEWLMRKPMKLX:HG
duty cycle 50%).
8LIWIXXMRKWJSVXLITVIQERSIYZVIƽEWLMRK[EVRMRKWMKREPQE]FIWIPIGXIH[MXLTEVEQ
eter
$
[LMPIXLIƽEWLMRKQSHIMWWIX[MXLTEVEQIXIV
.
13(ES) 11(COM)
Input for connecting electric lock, 12 Vdc max. 15 W
14(+24V) 11(COM)
Power feed for external devices. See technical characteristics.
16(+SC) 15(COM)
Connection for gate open indicator lamp.
:HG;ƼK
The function of the indicator lamp is determined by parameter
$
.
16(+SC) 15(COM)
Photocell test connection
ERHSVFEXXIV]WEZMRKƼKERH
8LITS[IVJIIHJSVXLITLSXSGIPPXVERWQMXXIVW8<QE]FIGSRRIGXIHXSXLMW
Set the parameter
$
to enable the test function.
Each time a command is received, the control unit switches the photocells off and on to
check that the contact changes state correctly.
Power feeds for all external devices may be connected to reduce battery consumption (if
batteries are used). Set
$
or
$
.
WARNING!
If contact
16 (SC)
is used for the photocell test function or battery saving
function, a gate open indicator lamp cannot be connected.
18(FT2) 15(COM)
Input (NC) for connecting photocells
FT2
ƼK
The photocells
FT2
EVIGSRƼKYVIHF]HIJEYPX[MXLXLIJSPPS[MRKWIXXMRKW
–
. Photocell FT2 disabled when gate is opening.
–
. Photocell FT2 disabled when gate is closing.
–
. The gate opens when an open command is received if photocell FT2 is
obstructed.
If the photocells are not installed, jumper the terminals
15(COM)
-
18(FT2)
or set the
parameters
and
.
WARNING
! Use
R90/F4ES
,
G90/F4ES
or
T90/F4S
series photocells.
19(FT1) 15(COM)
Input (NC) for connecting photocells
FT1
ƼK
The photocells
FT1
EVIGSRƼKYVIHF]HIJEYPX[MXLXLIJSPPS[MRKWIXXMRKW
–
. Photocell triggers only during gate closure. Photocell is ignored during gate
opening.
–
. Movement is reversed if the photocell is triggered during gate closure.
–
. The gate opens when an open command is received if photocell FT1 is
obstructed.
If the photocells are not installed, jumper the terminals
19(FT1) - 15(COM)
or set the
parameters
and
.
WARNING
! Use
R90/F4ES
,
G90/F4ES
or
T90/F4S
series photocells.
