Rodia DC 1450TS, Operating Manual

Page: 22 / 39

15
RODIA
®
DC 1450TS
GB
attention to the following items:
• Read the instructions for setting up and
using the machine carefully.
• Check that the power cord is correctly
connected to the power supply.
• Electrical cables may not come in con-
tact with water or spray water.
• Damaged cutting blades should be
replaced immediately.
technIcAl dAtA
Type . . . . . . . . Rodia DC 1450TS
Capacity . 230 V~/50 Hz/2,2 kW (2 HP)
No load motor speed . . . . . .2.800 RPM
Saw spindle speed . . . . . . . .1.680 RPM
Blade diameter/hole . . Ø250/25,4 mm
Cutting height single cut . . . . . . . 140 mm
Cutting height double cut* . . . . . 200 mm
Cutting length . . . . . . . . . . . . . 500 mm
Cutting table dimensions . 500 x 480 mm
Length . . . . . . . . . . . . . . . 1.240 mm
Width . . . . . . . . . . . . . . . . . 620 mm
Height . . . . . . . . . . . . . . . 1.330 mm
Weiht . . . . . . . . . . . . . . . . . . .91 kg
Noise level . . . . . . . . . . . . . . 84 dB (A)
Noise level during sawing . . . . 98 dB (A)
Diameter suction port . . . . . . . . . 63 mm
* Higher adjustment of the saw head may however
affect the suction.
IntroductIon
The Rodia DC 1450TS is, combined with
a Pullman-Ermator S26 or Pullman Erma-
tor S36 type vacuum cleaner, a by TNO
approved system for the professional for
dry cutting of stone and/or blocks.
For choice using a TNO approved vac-
uum cleaner see the table below.
Intensity of use Pullman-Ermator S26
400 m³/hr. or equivalent
Pullman-Ermator S36
600 m³/hr. or equivalent
Low: 1 a 2 hours per day x x
High: > 2 hours per day – x
x = suitable, – = not suitable
At high intensity of use of the brick saw (2
to 8 hours per day) one can choose for
the Pullman Ermator S36 with a capacity
of 600 m³/h or for an equivalent TNO
approved vacuum cleaner. By connecting
such a vacuum cleaner dust is prevented
and the allowable concentration of respir-
able quartz remains under the legal limit of
0,075mg/m³.
The machine is provided with a movable
cutting table, to which is fixed a stain-
less steel suction unit with a suction port
of Ø 63 mm and a retractable brush for
optimal suction. The movable cutting table
has 4 ball bearing guide rollers for precise
and easy cutting feed.The machine is
equipped with a height adjustable cutting
head. Higher adjustment of the cutting
head may however affect the suction.
The quality and construction of this brick
saw meet the highest standards. The
design is based on longevity and minimal
maintenance.
electrIcIty And sAfety
ATTENTION! On construction
sites electrical appliances should
be connected to specially
designed power supplies. Suita-
ble are grounded main power
supplies equipped with an earth-
leak switch of max. 30mA or
separating transformers.