18
RODIA
®
405TS-406TS
GB
on the saw spindle with a hexagon nut
to clamp the saw blade.
(Attention: Left-
handed screw thread)
Saw table
The saw table is constructed of welded
stainless steel components, equipped with
anti-slip rubber and adjustable side stop.
The saw table is equipped with 4 ball
bearing guide rollers for precise and easy
cutting feed.
Cooling system
The electrical water pump is switched on
simultaneously with the saw motor and
supplies cooling water to both sides of the
saw blade. A drain hole, with a plug, is
located in the water container. Mud flaps
prevent most of the water mist and make
sure most water flows back in the water
container.
6. UNPACKING AND SET UP
Setting up
• Unpack the sawing machine and
inspect for any damaged parts.
• Install the legs in the sockets at the
underside of the water container and
fasten with the knobs.
• Level the sawing machine by adjusting
the legs in the sockets and make sure
its stable.
• Release the transportation lock.
Saw head
• By loosening the lever the saw head
can be positioned at the desired
height.
Cooling system
ATTENTION!
Operating the water pump with-
out a sufficient supply of water
may result in pump damage.
• Place the plug in the drain of the water
container.
• Fill up the container with water until
the water pump is submerged till the
pumpgrip.
Connecting to power supply
First, check whether:
• the line voltage corresponds with the
data on the machineís specifications
plate,
• there is a grounded power supply,
• the extension cord wire cross-section is
at least 2,5 mm
2
.
Motor protection
The motor is equipped with a thermal
safety switch for protection against an
overload. When the motor gets over-
heated, the switch falls back into its initial
