- 11 -
- 12 -
5.
+48V power switch
: short press + or – button
until +48V POWER is displayed. Then, long press
the menu button to choose ON or OFF. Short press
+ or – button to switch.
6.
Software version
: When short pressing the + or
– button, the Version displayed means the software
version.
Version
1.00
7.
Restore factory default
: short press +/- button
until Restore Default is displayed. Then, long press
the menu to set. After restore the settings, the
system will set CRP/CH/RF : A-01-L by default.
+48V POWER
ON
Make the output port of the XLR microphone into the TX3-XLR
transmitter port and press down until it is locked.
Install/Detach the Microphone
Please do not pull out the microphone or XLR audio cable by force, otherwise,
damage may be caused.
Please turn off the transmitter when connecting or removing the microphone.
Note
：
Release button
Model
TX3-XLR
Channel
96(Group A 48；Group B 48)
Group
A/B
RF Frequency Range
514MHz-596MHz
Oscillator Type
Crystal Controlled PLL Synthesizer
Audio Frequency Range
40Hz-18KHz
Sound Delay
12ms
Distortion
＜0.5%
Antenna
1/4λ
Battery
Two AA batteries
Working Temperature
Range
0℃～ 40℃
Storage Temperature
-10℃～ 40℃
Dimensions
Weight
158g(Battery is not contained)
107mmx51mmx34mm
Troubleshooting
Technical Data
Unable to receive audio signal. Make sure batteries are installed
correctly and Power Switch is turned on. Check if the transmitter and
the receiver are set to the same channel, if the microphone or
earphone is well connected, or if the devices are set to the correct
mode.
Check if the transmitter is set to silent mode or not.
Signal disturbance or shooting interference. Change a different
channel of the transmitter and receiver.
Operating audio distance limited or signal missing. Check if batteries
are exhausted. If so,replace them.
1.
2.
3.
4.
Restore
Default
Microphone
or XLR cable
-
-
